Kodak 2400DSV-E Operator's Manual page 69

Appendix B User and System Settings
System Setting
Auto reset
Auto power save
(PR mode only)
Auto Projection Lamp
OFF
Fine mode contrast select
A-61316 September 2004
This system offers two types of settings:
• User settings that are setup by the operator from the control panel
• System settings that are setup and can be changed by the Kodak
Service Representative.
Following is a list of factory settings:
User Setting
Exposure mode
Print image density
Print format
Film type
Auto skew correction
Auto masking
Manual masking
Centering/Fit
When any of these functions has been changed and you want to store the
new setting in the system's memory, press the Memory Input key.
Selection Default
Enabled
Enabled
Disabled
Disabled
Disabled
30 min.
60 min.
Disabled
Disabled
30 min.
60 min.
Contrast
Contast
Emphasis
Emphasis
Outline
Emphasis
Factory
Setting
Auto
Center
Portrait
Auto
Off
Off
- Enabled only when the optional
Manual Frame Masking Kit is
installed.
Off
Description
Setting changes made to the control panel that are not
used within 60 seconds of being input are automatically
cancelled and the system reverts back to the original
settings.
Turns the printer's fuser off if the system is left idle for a
specific period of time.
NOTE: 230V units operate on a 30-minute Auto Power
Save setting.
Turns the projection lamp off if the system is left idle for a
specified period of time.
Applies the following functions as required:
Contrast Emphasis: applied when film contains text
that is poorly contrasted against its background
making it difficult to read.
Outline Emphasis: applied when film contains blurred
black and white images.
Comments
B-1