HP PROCURVE 6208M-SX Installation And Getting Started Manual page 98

Field
connection
The show web command displays the privilege level of Web management interface users. For example:
HP6208(config)#show web
User
set
Syntax: show web
USING THE WEB MANAGEMENT INTERFACE
To configure RADIUS using the Web management interface:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. If you configuring RADIUS authentication for Telnet access to the CLI, go to step 3. Otherwise, go to step 7.
3. Select the Management link to display the Management configuration panel.
4. Select Enable next to Telnet Authentication. You must enable Telnet authentication if you want to use
TACACS/TACACS+ or RADIUS to authenticate Telnet access to the device.
5. Click Apply to apply the change.
6. Select the Home link to return to the System configuration panel.
7. Select the RADIUS link from the System configuration panel to display the RADIUS panel.
8. Change the retransmit interval, time out, and dead time if needed.
9. Enter the authentication key if applicable.
10. Click Apply if you changed any RADIUS parameters.
11. Select the RADIUS Server link.
• If any RADIUS servers are already configured on the device, the servers are listed in a table. Select the
Add RADIUS Server link to display the following panel.
• If the device does not have any RADIUS servers configured, the following panel is displayed.
Table 3.6: Output of the show aaa command for RADIUS
Description
The current connection status.
Privi lege
Th is can be "no connection" or "connection active".
IP address
0 192.168.1.234
Securing Access
3 - 41