HP PROCURVE 6208M-SX Installation And Getting Started Manual page 196

To display information about SNTP associations, enter the following command:
HP9300# show sntp associations
address ref clock
~207.95.6.102 0.0.0.0
~207.95.6.101 0.0.0.0
* synced, ~ configured
Syntax: show sntp associations
The following table describes the information displayed by the show sntp associations command.
Table 9.1: Output from the show sntp associations command
This Field...
(leading character)
address
ref clock
st
when
poll
delay
disp
To display information about SNTP status, enter the following command:
HP9300# show sntp status
Clock is unsynchronized, stratum = 0, no reference clock
precision is 2**0
reference time is 0
clock offset is 0.0
root dispersion is 0.0
Syntax: show sntp status
The following table describes the information displayed by the show sntp status command.
Table 9.2: Output from the show sntp status command
This Field...
unsynchronized
synchronized
stratum
reference clock
precision
reference time
st when
16 202
16 202
Displays...
One or both of the following:
* Synchronized to this peer
~ Peer is statically configured
IP address of the peer
IP address of the peer's reference clock
NTP stratum level of the peer
Amount of time since the last NTP packet was received from the peer
Poll interval in seconds
Round trip delay in milliseconds
Dispersion in seconds
.0
msec, root delay is 0.0
msec, peer dispersion is 0.0
Indicates...
System is not synchronized to an NTP peer.
System is synchronized to an NTP peer.
NTP stratum level of this system
IP Address of the peer (if any) to which the unit is synchronized
Precision of this system's clock (in Hz)
Reference time stamp
poll delay disp
4 0.0 5.45
0 0.0 0.0
msec
msec
Configuring Basic Features
9 - 11