Installation and Getting Started Guide
•
For read-write access, enter "set" in the User Name field and a read-write community string that you have
configured on the device in the Password field, as shown in Figure 7.1. (For security, the software displays
asterisks when you type your password.)
•
For read-only access, enter "get" in the User Name field and "public" (the default read-only community string)
or a read-only community string you have configured in the Password field.
NOTE: The software does not contain a default read-write SNMP community string. You must configure a read
write string before you can make configuration changes using the Web management interface. See "Adding an
SNMP Community String" on page 3-14.
On the HP 9304M or HP 9308M, if you have configured a greeting banner (using the banner motd CLI
command), a panel with the greeting is displayed first. Click on the Login link to proceed to the Login dialog. Here
is an example of the greeting panel:
Figure 7.2 shows an example of the Web management display of an HP 9304M or HP 9308M routing switch.
Figure 7.2
Example of Web management interface
The configuration and management procedures in this guide include instructions for the Web management
interface.
7 - 8