HP PROCURVE 6208M-SX Installation And Getting Started Manual page 120

3. Click the Add Module link to display the following panel.
4. Select slot number from the Slot pulldown menu.
• Slots on the HP 9304M are numbered 1 – 4, from top to bottom.
• Slots on the HP 9308M are numbered 1 – 8, from left to right.
5. Select the module type from the Module Type pulldown menu.
6. Click the Add button to save the change to the device's running-config file.
7. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
The configuration change is saved to the active redundant management module's startup-config file. (The
change is automatically sent to the standby module when the active module's system-config file is copied to
the standby module.)
NOTE: You also can access the dialog for saving configuration changes by clicking on Command in the tree
view, then clicking on Save to Flash.
Specifying the Default Active Module
By default, the redundant management module in the lower slot number becomes the active redundant
management module when you start the system. For example, if you install redundant management modules in
slots 1 and 8 in an HP 9308M chassis, the default active module is the module in slot 1.
NOTE:
• Slots on the HP 9304M are numbered 1 – 4, from top to bottom.
• Slots on the HP 9308M are numbered 1 – 8, from left to right.
You can override the default and specify the active module.
NOTE: The change does not take effect until you reload the system. If you save the change to the active
module's system-config file before reloading, the change persists across system reloads. Otherwise, the change
affects only the next system reload.
USING THE CLI
To override the default and specify the active redundant management module, enter the following commands:
HP9300(config)# redundancy
HP9300(config-redundancy)# active-management 5
Syntax: active-management <slot-num>
Using Redundant Management Modules
5 - 5