HP PROCURVE 6208M-SX Installation And Getting Started Manual page 128

USING THE CLI
To immediately synchronize the boot code on the standby module with the boot code on the active module, enter
the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby boot
Syntax: sync-standby boot
To immediately synchronize the flash code (system software) on the standby module with the boot code on the
active module, enter the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby code
Syntax: sync-standby code
To immediately synchronize the running-config on the standby module with the running-config on the active
module, enter the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby running-config
Syntax: sync-standby running-config
To immediately synchronize the startup-config file on the standby module with the startup-config file on the active
module, enter the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby startup-config
Syntax: sync-standby startup-config
USING THE WEB MANAGEMENT INTERFACE
NOTE: This procedure applies only to synchronizing the boot code and the running-config. To immediately
synchronize the flash code or the startup-config file, use the CLI procedure above.
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Select the Redundant link to display the following panel.
3. Click the button for the code or file you want to immediately synchronize:
• To synchronize the running-config, select the Synchronize Configuration Now button.
• To synchronize the boot flash code, select the Synchronize Boot Flash Now button.
As soon as you click the button, the Web management interface immediately performs the synchronization.
Using Redundant Management Modules
5 - 13