HP PROCURVE 6208M-SX Installation And Getting Started Manual page 87

Installation and Getting Started Guide
The authorization method you selected are displayed in the table at the top of the dialog. Each time you add
an authorization method for a given access type, the software assigns a sequence number to the entry.
When authorization is performed, the software tries the authorization sources in ascending sequence order
until the request is either approved or denied. Each time you add an entry for a given access type, the
software increments the sequence number. Thus, if you want to use multiple authentication methods, make
sure you enter the primary authentication method first, the secondary authentication method second, and so
on.
If you need to delete an entry, select the access type and authorization method for the entry, then click Delete.
26. To configure TACACS+ accounting, select the Management link to display the Management panel and select
the Accounting Methods link to display the Accounting Method panel, as shown in the following example.
27. To send an Accounting Start packet to the TACACS+ accounting server when an authenticated user
establishes a Telnet or SSH session on the HP device, and an Accounting Stop packet when the user logs
out, select Exec from the Type field's pulldown menu.
28. To configure TACACS+ accounting for CLI commands, select Commands from the Type field's pulldown
menu and select a privilege level by clicking on one of the following radio buttons:
• 0 – Records commands available at the Super User level (all commands)
• 4 – Records commands available at the Port Configuration level (port-config and read-only commands)
• 5 – Records commands available at the Read Only level (read-only commands)
29. To configure TACACS+ accounting to record when system events occur on the HP device, select System
from the Type field's pulldown menu.
30. Click on the radio button next to TACACS+.
31. Click the Add button to save the change to the device's running-config file.
The accounting method you selected are displayed in the table at the top of the dialog. Each time you add an
accounting method for a given access type, the software assigns a sequence number to the entry. When
accounting is performed, the software tries the accounting sources in ascending sequence order until the
request is either approved or denied. Each time you add an entry for a given access type, the software
increments the sequence number. Thus, if you want to use multiple accounting methods, make sure you
enter the primary accounting method first, the secondary accounting method second, and so on.
If you need to delete an entry, select the access type and accounting method for the entry, then click Delete.
32. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
3 - 30