HP PROCURVE 6208M-SX Installation And Getting Started Manual page 202

• sys14 – reserved for system use
• cron – cron/at subsystem
• local0 – reserved for local use
• local1 – reserved for local use
• local2 – reserved for local use
• local3 – reserved for local use
• local4 – reserved for local use
• local5 – reserved for local use
• local6 – reserved for local use
• local7 – reserved for local use
Displaying the Syslog Configuration
To display the Syslog parameters currently in effect on an HP device, enter the following command from any level
of the CLI:
HP9300> show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
B uffer logging: level ACDMEINW, 3 messages logged
l evel code: A=alert C=critical D=debugging M=emergency E=error
I=inf ormational N=notification W=warning
Static Log Buffer:
Dec 15 19:04:14:A:Fan 1, fan on right connector, failed
Dynamic Log Buffer (50 entries):
Dec 15 18:46:17:I:Interface ethernet4, state up
Dec 15 18:45:21:I:Bridge topology change, vlan 4095, interface 4, changed
state to forwarding
Dec 15 18:45:15:I:Warm start
Syntax: show logging
The value "ACDMEINW" indicates message levels that are enabled. Each letter represents a message type and
is identified by the key below the value. For examples of Syslog messages, see the Command Line Interface
Reference.
USING THE WEB MANAGEMENT INTERFACE
To configure Syslog parameters using the Web management interface, use the following procedure:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select Management from the System configuration sheet to display the Management panel.
3. Select the System Log link to display the following panel.
Configuring Basic Features
9 - 17