HP PROCURVE 6208M-SX Installation And Getting Started Manual page 139

Installation and Getting Started Guide
Compressed Secondary Code size = 0, Version
Maximum Code Image Size Supported: 2817536 (0x002afe00)
Boot Image Version 07.01.01
c. Copy the software image file you just saved (in step a) from the TFTP server back to secondary flash on
the routing switch and verify that the code is stored in secondary flash. For example:
HP9308# copy tftp flash 192.168.1.1 H2R06616.bin sec
HP9308# Flash Erase ------------------------------------------
Flash Memory Write (8192 bytes per dot)
............................................................................
........................................................TFTP to Flash Done.
HP9308# show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 2
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Primary Code size = 2579100, Version 07.1.10T53
Compressed Secondary Code size = 2053824, Version 06.6.16T53
Maximum Code Image Size Supported: 2817536 (0x002afe00)
Boot Image Version 07.01.01
The "size" and "Version" values in the "Compressed Secondary Code" line, above, indicate that the soft­
ware image file has been successfully reloaded into secondary flash. You have now verified that your
communication with the TFTP server is working properly.
3. Download the appropriate boot code from the HP Procurve website to your TFTP server. (Go to http://
www.hp.com/go/hpprocurve and click on software.)
4. Use the (undocumented) boot command shown below to initiate the TFTP download. For example, to
download the M2B07105.bin boot code from a TFTP server at 192.168.1.1.
CAUTION: It is extremely important that the TFTP download of the boot code is not interrupted. An
interruption in this process can result in a non-bootable system. If for any reason the boot code download is
not successful, please do not use the reload command in the next step. Instead, contact an HP Customer
Care Center immediately. To find the HP Customer Care Center for your area, see the support and warranty
booklet shipped with your routing switch product, or see the HP Procurve Networking Service and Support
Guide available on HP's Procurve website at http://www.hp.com/go/hpprocurve. (Click on technical
support and then support services.)
HP9308# copy tftp flash 192.168.1.1 M2B07105.bin boot
HP9308# Writing to flash, please wait ... Done
HP9308# show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 2
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Primary Code size = 2579100, Version 07.1.10T53
Compressed Secondary Code size = 2053824, Version 06.6.16T53
Maximum Code Image Size Supported: 2817536 (0x002afe00)
Boot Image Version 07.01.05
Note that in the preceding example, the Boot Image Version number (07.01.05) at the end of step 4, above,
is a later (higher) version than the Boot Image Version number (07.01.01) at the end of step 1. This
indicates a successful download of a new boot image to the routing switch.
5. Execute the reload command to ensure that the boot code operates properly:
HP9308# reload
6 - 4