HP PROCURVE 6208M-SX Installation And Getting Started Manual page 245

Installation and Getting Started Guide
atalk-route
atalk-zone-port
atalk-zone-sys
dvmrp
igmp
ip-cache
ip-filter-port
ip-filter-sys
ipx-forward-filter
ipx-rip-entry
ipx-rip-filter
ipx-sap-entry
ipx-sap-filter
l3-vlan
ip-qos-session
l4-real-server
l4-virtual-server
l4-server-port
mac
ip-route
ip-static-route
vlan
spanning-tree
mac-filter-port
mac-filter-sys
ip-subnet-port
session-limit
view
virtual-interface
Information for the configurable tables appears under the columns that are shown in bold type in this example. To
simplify configuration, the command parameter you enter to configure the table is used for the table name. For
example, to increase the capacity of the IP route table, enter the following commands:
HP9300(config)# system-max ip-route 120000
HP9300(config)# write memory
HP9300(config)# exit
HP9300# reload
NOTE: If you accidentally enter a value that is not within the valid range of values, the CLI will display the valid
range for you.
To increase the number of IP sub-net interfaces you can configure on each port on a routing switch from 24 to 64,
then increase the total number of IP interfaces you can configure on the device from 256 to 512, enter the
following commands:
HP9300(config)# system-max subnet-per-interface 64
HP9300(config)# write memory
HP9300(config)# exit
HP9300# reload
Syntax: system-max subnet-per-interface <num>
The <num> parameter specifies the maximum number of sub-net addresses per port and can be from 1 – 64. The
default is 24.
Syntax: system-max subnet-per-system <num>
9 - 60
512 1536
64 255
255 1024
2048 32000
256 1024
128000 256000
512 4096
1024 8192
256 1024
3072 32728
256 1024
6144 32768
256 1024
32 2048
2048 32000
1024 2048
256 512
2048 4096
8000 64000
128000 200000
512 2048
16 2048
32 128
32 512
64 1024
24 128
131072 500000
10 65535
255 2048
512
64
255
2048
256
128000
512
1024
256
3072
256
6144
256
32
2048
1024
256
2048
8000
128000
512
16
32
32
64
24
131072
10
255