HP PROCURVE 6208M-SX Installation And Getting Started Manual page 218

USING THE WEB MANAGEMENT INTERFACE
To enable port-based VLANs on the switch or routing switch:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select the box next to Port, next to Policy Based VLANs.
3. Click Apply to save the changes to the device's running-config file.
4. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
Assigning IEEE 802.1q Tagging to a Port
When a port is tagged, it allows communication among the different VLANs to which it is assigned. A common
use for this might be to place an email server that multiple groups may need access to on a tagged port, which in
turn, is resident in all VLANs that need access to the server.
NOTE: Tagging is disabled by default on individual ports.
NOTE: Tagging does not apply to the default VLAN.
For details on configuring port-based VLANs, see the "Configuring Virtual LANs (VLANs)" chapter in the
Advanced Configuration and Management Guide.
USING THE CLI
When using the CLI, ports are defined as either tagged or untagged at the VLAN level.
EXAMPLE:
Suppose you want to make port 5 on module 1 a member of port-based VLAN 4, a tagged port. To do so, enter
the following:
HP9300(config)# vlan 4
HP9300(config-vlan-4)# tagged e 1/5
Syntax: tagged ethernet <portnum> [to <portnum> [ethernet <portnum>]]
USING THE WEB MANAGEMENT INTERFACE
To apply 802.1q tagging to a port:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Select the Port link to display the Port table.
4. Click on the Modify button next to the row of information for the port you want to reconfigure.
5. Select Enable next to IEEE Tagging.
NOTE: This option appears only if you are modifying a port that is a member of a port-based VLAN other
than the default VLAN. Tagging does not apply to ports that are not in a port-based VLAN and does not apply
to the default VLAN.
6. Click Apply to save the changes to the device's running-config file.
7. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
Configuring Basic Features
9 - 33