Rebooting From The Menu Interface - HP ProCurve series 2500 Management And Configuration Manual

Rebooting from the Menu Interface

I
I
I
(Note that statistical counters can be reset to zero without rebooting the
switch. See "Displaying Port Counters" on page 10-9.)
To Reboot the switch, use the Reboot Switch option in the Main Menu. (Note
that the Reboot Switch option is not available if you log on in Operator mode;
that is, if you enter an Operator password instead of a manager password at
the password prompt.)
Reboot Switch option
Figure 11-73.The Reboot Switch Option in the Main Menu
Rebooting To Activate Configuration Changes. Configuration changes
for most parameters become effective as soon as you save them. However,
you must reboot the switch in order to implement a change in the
VLANs to support
(To access these parameters, go to the Main menu and select 2. Switch
Configuration, then 8. VLAN Menu, then
Using the Menu and Web Browser Interfaces To Implement Configuration Changes
Terminates the current session and performs a reset of the operating
system
Activates any configuration changes that require a reboot
Resets statistical counters to zero
parameter
.
Switch Memory and Configuration
.)
1. VLAN Support
Maximum
C-9