Changing Interfaces - HP ProCurve series 2500 Management And Configuration Manual

Using the Command Line Interface (CLI)
Using the CLI
Changing Interfaces. If you change from the CLI to the menu interface, or
the reverse, you will remain at the same privilege level. For example, entering
the
Operator privilege level in the menu interface.
Table 3-1.
Privilege Level Example of Prompt and Permitted Operations
Operator Privilege
Operator Level HP2512>
Manager Privilige
Manager Level HP2512#
Global HP2512(config)#
Configuration
Level
Context HP2512(eth-5)#
Configuration HP2512(vlan-100)#
Level
3-6
command from the Operator level of the CLI takes you to the
Privilege Level Hierarchy
show <command>
View status and configuration information.
setup
ping <argument>
Perform connectivity tests.
link-test <argument>
enable
Move from the Operator level to the Manager level.
Move from the CLI interface to the menu interface.
menu
Exit from the CLI interface and terminate the console
logoff
session.
Perform system-level actions such as system control, monitoring, and diagnostic
commands, plus any of the Operator-level commands. For a list of available
?
commands, enter at the prompt.
Execute configuration commands, plus all Operator and Manager commands . For
a list of available commands, enter
Execute context-specific configuration commands, such as a particular VLAN or
switch port. This is useful for shortening the command strings you type, and for
entering a series of commands for the same context. For a list of available
?
commands, enter at the prompt.
?
at the prompt.