HP ProCurve series 2500 Management And Configuration Manual page 261

Procurve 2500 series
Hide thumbs Also See for HP ProCurve series 2500:
Table of Contents

Advertisement

Converting a Dynamic VLAN to a Static VLAN. If GVRP is running on
the switch and a port dynamically joins a VLAN, you can use the next
command to convert the dynamic VLAN to a static VLAN. (For GVRP and
dynamic VLAN operation, see "GVRP" on page 9-77.) This is necessary if you
want to make the VLAN permanent. Note that after you convert a dynamic
VLAN to static, you must configure the switch's per-port participation in the
VLAN in the same way that you would for any static VLAN.
Syntax:
If you need a VID reference, use show vlan to list the switch's currently existing
VLANs.
For example, suppose a dynamic VLAN with a VID of 125 exists on the switch.
The following command converts the VLAN to a static VLAN.
Configuring Static VLAN Name and Per-Port Settings. The vlan <vlan-
id> command, used in conjunction with the options listed below, enables you
to change the name of an existing static VLAN and change the per-port VLAN
membership settings as show below.
N o t e
You can use these options from the configuration level by beginning the
command with vlan <vlan-id>, or from the context level of the specific VLAN.
Syntax:
static-vlan <vlan-id>
name <vlan-name>
[no] tagged <port-list>
[no] untagged <port-list> Configures the indicated port(s) as
[no] forbid <port-list>
auto <port-list>
Configuring Advanced Features
Port-Based Virtual LANs (Static VLANs)
Changes the name of the existing
static VLAN. (No spaces allowed in the
<vlan-name> entry.
Configures the indicated port(s) as
Tagged for the specified VLAN. The
"no" version sets the port(s) to
either No or (if GVRP is enabled) to Auto.
Untagged for the specified VLAN. The
"no" version sets the port(s) to
either No or (if GVRP is enabled) to Auto.
Configures the indicated port(s) as
"forbidden" to participate in the
designated VLAN. The "no" version sets
the port(s) to either No or (if GVRP is
enabled) to Auto.
Available if GVRP is enabled on the
switch. Returns the per-port settings
for the specified VLAN to Auto
9-67

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 2512Procurve 2524

Table of Contents