HP ProCurve series 2500 Management And Configuration Manual page 376

Switch Memory and Configuration
Using the Menu and Web Browser Interfaces To Implement Configuration Changes
Using
For any configuration screen in the menu interface, the Save command:
1.
2.
If you decide not to save and implement the changes in the screen, select
Cancel to discard them and continue switch operation with the curent opera-
tion. For example, suppose you have made the changes shown below in the
System Information screen:
To save and
implement the
changes for all
parameters in this
screen, press the
[Enter] key, then press
[S] (for Save). To
cancel all changes,
press the [Enter] key,
then press [C] (for
Cancel)
Figure 2-11. Example of Pending Configuration Changes that Can Be Saved or
N o t e
If you reconfigure a parameter in the CLI and then go to the menu interface
without executing a write memory command, those changes are stored only in
the running configuration (even if you execute a Save operation in the menu
interface). If you then execute a switch reboot command in the menu inter-
face, the switch discards the configuration changes made while using the CLI.
To ensure that changes made while using the CLI are saved, execute write
memory in the CLI before rebooting the switch.
C-8
and in the Menu Interface
Save Cancel
Implements the changes in the running-config file
Saves your changes to the startup-config file
Cancelled