Connecting To Ethernet (Ethernet/Ip); Setting The Ip Address - Omron NE1A-EDR01 Operation Manual

Connecting to Ethernet (EtherNet/IP)

2-4

Connecting to Ethernet (EtherNet/IP)

2-4-1

Setting the IP Address

Method 1: Using the Default IP Address (192.168.250.IP_address_switch_set value)
Method 2: Setting the TCP/IP Configuration from the Network Configurator
18
This section describes methods for setting the IP address for the ED Router.
Method 1: The default IP address is 192.168.250.IP_address_switch_set
value.
The IP address is set with the rotary switches on the front of the
ED Router (IP ADR).
→ This method can be used to make a temporary or preliminary
connection to the Ethernet.
In this case, leave the TCP/IP Configuration setting at its
default value.
Method 2: Setting the TCP/IP Configuration from the Network Configura-
tor:
→ To set a particular local IP address, use the Network Configu-
rator.
The methods for setting the ED Router IP address are described below.
The default IP address for the ED Router is
192.168.250.IP_address_switch_set value. The IP address switch is used to
set the IP address host ID.
IP address = 192.168.250.IP_address_switch_set value
The host IC can be changed with the IP address switch. If 00 or FF is set, 01
will be used as the host ID.
The TCP/IP settings will be in the following default settings.
Setting
IP address
Subnet mask
Default gateway
Preferred DNS server
Alternate DNS server
Host name
Domain name
Baud rate
With this method, set the TCP/IP configuration, including the IP address, from
the Network Configurator.
Operating status
192.168.250.IP_address_switch_set value
255.255.255.0 (class C mask)
None (IP routing disabled)
None
None
None
None
Auto-detect
Section 2-4