NOTE
You should notice that the trace you saved, in this example trace 3, is loaded
to trace 2. If you wish to verify this condition, remove the signal input. Press
Input/Output
Note that when a trace is loaded, it is placed in view mode. To see that trace 2
is in view mode, blank traces 1 and 3 by pressing
,
Trace 3
displayed in view mode (the view key is selected, and the trace is not
sweeping). Your display should look similar to Figure 4-7.
Figure 4-6. Verifying Trace 1
CAUTION
When operating in dc coupled mode, ensure protection of the input mixer by
limiting the input level to 0 Vdc and +30 dBm.
When loading Limits files, be sure you have selected the appropriate X Axis
NOTE
Units: frequency or time (
time X-Axis Units, and you load frequency limits, all current limit line data
will be erased and the analyzer will switch to the frequency domain. The
reverse of the this situation also holds true.
Chapter 4
,
,
Input Port
Amptd Ref (Off)
. Then press Trace 2. Notice that trace 2 is the only trace
Blank
Display
.
View/Trace
,
,
,
Limits
Properties
X Axis Units
Viewing Catalogs and Saving Files
Saving a File
,
,
Trace 1
Blank,
). If you are in
53