Agilent Technologies E4440A Getting Started Manual page 18

Installation and Setup
Printer Setup and Operation
Interconnection and Setup
1. Turn off the printer and the analyzer.
2. Using an IEEE 1284 compliant parallel printer cable, connect the printer to the
analyzer parallel I/O interface connector on the rear panel (see
on page 27).
3. Turn on the analyzer and printer.
4. On the front panel, press
5. Select the printer language and color capability appropriate for your printer. See table
above this section for a list of some compatible printers.
Testing Printer Operation
When you have completed the printer setup for the analyzer, press the front panel
key. If the printer is ready and the printer setup was successful, a printout of the analyzer
display will be printed. If the printer is not ready, the message "Printer not responding"
appears at the bottom of the screen.
NOTE There may be some small discrepancies in the color mapping of the analyzer
display to your color printer. Due to differences in display and printer
technologies, the default display colors do not map exactly to the printer
colors. For example trace 1 is yellow on your analyzer display while it maps to
green on your printer.
18
, then press the
Print Setup
"Rear-Panel Features"
menu key.
Printer Setup
Print
Chapter 1