Ricoh 3045 Facsimile Reference Manual page 740

Monitoring and Configuring the Printer
Message
centrod is disabled.
Cannot create service connection
2
Cannot find rprinter (<print server
name>/<printer number>)
Change IP address from DHCP Server.
child process exec error! (process name)
Connected DHCP Server(<DHCP serverad-
dress>).
connection from <IP address>
Could not attach to FileServer<error number> (In the remote printer mode) Connection to the
Could not attach to PServer<print server>
Current Interface Speed:xxxMbps
Current IP address <current IP address>
Current IPX address<IPX address>
DHCP lease time expired.
DHCP server not found.
dhcpcd start.
dpsd is disabled.
Duplicate IP=<IP address>(from<MAC ad-
dress>).
102
Problem and solutions
Communication via parallel connection is un-
available because centrod is disabled in the se-
curity mode.
Enable centrod in the security mode.
(In the remote printer mode) Connection to the
file server has not been established. The
number of file server users may have exceeded
the maximum capacity of the file server.
The printer with the number displayed on the
print server does not exist. Make sure that the
printer number is registered on the print server.
The IP address changes when DHCP lease is re-
newed. To always assign the same IP address,
set a static IP address to the DHCP server.
The network service failed to start. Turn the
printer off and then on. If this does not work,
contact your service or sales representative.
The IP address was successfully received from
the DHCP server.
Login was from the host IP address.
file server has not been established. The file
server has refused the connection. Check the
file server configuration.
(In the remote printermode) Connection to the
print server has not been established. The
print server has refused the connection. Check
the print server configuration.
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
Current IPv4 address.
Current IPX address
DHCP lease time has expired. The printer tries
to discover the DHCP server again. The IP ad-
dress until now becomes invalid.
The DHCP server was not found. Make sure
that the DHCP is on the network.
The DHCPCD service (dhcp client service) has
started.
Communication via PictBridge is unavailable
because PictBridge is disabled in the security
mode. Enable PictBridge in the security mode.
The same IP address was used. Each IP ad-
dress must be unique. Check the address of the
device indicated in [MAC address].