Setting Paper On The Bypass Tray - Ricoh 3045 Facsimile Reference Manual

Setting Paper on the Bypass Tray

This section gives instructions for setting paper on the bypass tray.
For details about paper size and paper type, see "Recommended Paper Size and
Types", About This Machine.
Paper within the following dimensions can be set in the bypass tray:
• Vertical: 100 - 297 mm (3.9 - 11.7 in.)
• Horizontal: 148 - 600 mm (5.8 - 23.6 in.)
Important
❒ The following functions are disabled when printing from the bypass tray:
• Duplex printing (when the optional unit is installed)
• Auto Tray Select
• Auto Tray Switching
• Rotating collate
• Staple (when the optional unit is installed)
• Punch (when the optional 2 Tray Finisher is installed)
❒ Be sure to set the paper size using the printer driver when printing data from
the computer. The paper size set using the printer driver has priority over the
one set using the display panel.
❖ Printing onto paper with specific orientation
When printing onto paper that has specific orientation requirements, such as
envelopes or letterhead paper, be sure to set as the followings:
• If the paper feed orientation is L, insert paper print side down in the by-
pass tray, and set the bottom edge of the paper toward the machine.
• If the paper feed orientation is K, insert paper print side down in the by-
pass tray, and set the bottom edge of the paper toward you.
To print on paper that is set in the opposite position to either of the correct
positions described above, rotate the print image 180 degrees using the print-
er driver. For details, see the printer driver Help.
9