Ricoh 3045 Facsimile Reference Manual page 151

F
Press [OK] twice.
The standby display appears.
G
Specify a destination, and then press the {Start} key.
Note
❒ If the fax is not received normally, "Error" appears in the Result column.
❒ Only the last 50 communications appear in the Journal. If you do not re-
ceive a reception notice message before the last 50 communications are fin-
ished, "OK" might not be printed in the Journal's Result column. This may
happen even if the mail is received normally at the other end.
❒ If you specify mailing list addresses, do not set for Reception Notice. Oth-
erwise, you will receive multiple reception notice messages from e-mail re-
cipients, and the Result column will be overwritten each time a new notice
message is received. However, if you receive a reception notice message
indicating an error, "Error" appears in the Result column and will not be
overwritten, even if you subsequently receive a reception notice message
as "OK" following the error message.
❒ Reception notice results are only shown in the Journal. The Result column
in all other files, lists, and transmission reports show "--".
❒ Reception notice messages themselves are not recorded in the Journal.
❒ You can select whether or not to print the Reception Notice. This can be set
with User Parameters (switch 21, bit 0) in the Facsimile Features menu.
❒ You cannot broadcast e-mail using Reception Notice. The documents are
sent to the destinations in the order in which they were specified.
Reference
p.113 "Sender Settings"
"Facsimile Features", General Settings Guide
Sub Transmission Mode
141
2