Ricoh 3045 Facsimile Reference Manual page 721

Parameter
key [ "key value" ] val [1|2|3|4]
keyphrase [ "phrase" ] val [1|2|3|4]
encval [1|2|3|4]
auth [open|shared]
Remote Maintenance by telnet
Value configured
You can specify the WEP key when entering
in hexadecimal.
With a 64-bit WEP, you can use 10 digit hex-
adecimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Spec-
ify the number to be registered with "val".
When a WEP is specified by key, the WEP
specified by key phrase is overwritten.
To use this function, set the same key
number and WEP key for all ports that trans-
mit data to each other. Put "0x"on the front
of WEP key.
You can omit the numbers with "val". The
key number is set to 1 when making these
omissions. The default is blank.
You can specify the WEP key when entering
in ASCII.
With a 64-bit WEP, you can use10 digit hex-
adecimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Spec-
ify the number to be registered with "val".
When a WEP is specified by key phrase, the
WEP specified by key is overwritten.
To use this function, set the same key
number and WEP key for all ports that trans-
mit data to each other.
You can omit the numbers with "val". The
key number is set to1 when making these
omissions. The default is blank.
You can specify which of the four WEP keys
is used for packet encoding. "1" is set if a
number is not specified.
You can set an authorization mode when us-
ing WEP. The specified value and authorized
mode are as follows:
open: open system authorized (default)
shared: shared key authorized rate
2
83