Problems When Projection Starts; The Projector Does Not Turn On; Other Problems; No Sound Can Be Heard Or The Sound Is Faint - Epson EB-D6250 User Manual

Problem Solving

Problems when Projection Starts

The projector does not turn on

Check
Did you press the [t] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
Is the Control Panel Lock set to Full Lock?
Is the correct setting for the remote receiver selected?
Was the power cable plugged back in or was the breaker turned on
immediately after Direct Power Off?

Other Problems

No sound can be heard or the sound is faint

Check
Check that the audio/video cable is securely attached to both the
projector and audio source.
Is the volume adjusted to the minimum setting?
Press the [t] button to turn the power on.
The power cable is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cable.
s "From Installation to Projection" p.30
Check that your electrical outlet or power source is functioning correctly.
does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the setting to Off.
s Settings - Control Panel Lock p.68
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.68
If the operation to the left is performed when Direct Power On is set to On, the power may not turn back on. Press the
[t] button to turn the power back on.
Disconnect the cable from the Audio port, and then reconnect the cable.
Adjust the volume so that sound can be heard.
s Settings - Volume p.68
s "Adjusting the Volume" p.37
Remedy
Remedy
94