Usb Multi-Touch Panel - Contec IPC-DT User Manual

USB Multi-Touch Panel

This function can be used in the case when the RGB signal from the
host computer is split for connecting to multiple displays via a
splitter. The function permits touch panel operation to be used at
all the displays. A maximum of eight touch panel displays can be
connected.
Note that all touch panels must be connected via USB and, to allow
the touch panel driver software on the host computer to identify
each device, a different USB ID must be set on the DIP switch
located on the side of each display unit.
Host PC
Figure 9.2. Example of connection of a USB multi-touch
You can use a CONTEC IPC-PT/600 series panel computer as the
host PC.
In this case, the ID of the touch panel in the panel computer is fixed
at ID7. Set the IDs of the external displays in the range
USB ID0 - USB ID6 (a maximum of seven external displays can be
connected).
Note!
You cannot use multiple touch panels via the RS-232C interface.
User's Manual
RGB distributor RGB cable
USB HUB USB cable
panel
USB ID7
USB ID0
Touch panel display
9. Touch Panel
8 sets(Max.)
41