Power Supply Connection; Power Supply Connector - Contec IPC-DT User Manual

6. Power Supply Connection

This equipment requires power supply at +12 VDC to operate.
For power supply, it has the power connector and the AC adapter
jack.
Notes!
- Connect a power supply to either of the power connector and
adapter jack. Never supply power to both of them at the same
time as it can cause a fault.
- If you connect a power supply other than the option, be sure to
take safety measures for the power supply, such as overvoltage
protection. Use meticulous care not to mistake the connection
polarity or voltage of the power supply as it may break the
equipment, the power supply, or both.

Power Supply Connector

The AC power supply unit [IPC-POA200/12-01] available as an
option can be connected.
You connect a power supply other than the option, be sure to use the
one that satisfies the following requirements:
- Power supply voltage: +12VDC 5%
- Power supply capacity: 2.5A or more
The table below lists the pin specifications of the power connector
on the back of the equipment.
Table 6.1. Power Supply Connector
Connector type
Model
Pin No.
* To use a power supply other than the optional AC power supply
unit, prepare a cable connector separately.
User's Manual
+12 VDC input connector
B4PS-VH(manufactured by JST)
1 2 3 4
Signal name
1 GND
2 GND
3 +12V
4 +12V
6. Power Supply Connection
Applicable power cable connector
Housing: VHR-4N (manufactured by JST)
Contact: SVH-21T-1.1(AWG22-18)
(manufactured by JST)
27