Direct Key; Memory Of A Setting Value - Contec IPC-DT User Manual

7. Screen Adjustment and a Setup

Direct Key

BRIGHTNESS :
INITIALIZATION: All the settings can be reset to the factory
Power save mode:
* Recycling the power to the equipment in the power save mode
recovers it to the normal display state.
* The POWER LED on the front face remains blinking in green in
the power save mode.

Memory of a Setting Value

The equipment retains its settings even when the power is turned
off.
Note, however, that the following settings are reset to their defaults
without being retained.
- The power save mode setting made by the direct key is reset to the
normal state when the power is turned on.
- The TOUCH PANEL ON/OFF setting is set to OFF when the
power is turned on.
36
The brightness of the backlight can be adjusted
by pressing the [+] and [-] keys without the
menu screen displayed.
defaults by turning on the equipment while
holding down the [MENU] key.
You can place the equipment in the power save
mode by depressing both of the [+] and [-]
keys at the same time without the menu screen
displayed. This can force the screen display
and backlight to be turned off.
Release the buttons when "!POWERSAVE
MODE" appears on the screen.
You can recover the screen from the power
save mode by pressing any of the front
switches. The power consumption of the
equipment in the power save mode is about 1/5
of that during normal operation. Turning off
the backlight when not required the backlight
to extend its life.
User's Manual