Table of Contents
Advertisement
Sheet Paper Loading
This dot printer can print sheet paper Oetter paper) with widths of 8.3 to 8.5 inches (210 to 216mmL
Load the sheet paper in the following steps.
STEP 1.
Raise the printer cover.
Pull the release lever to
ward you and turn down the scale.
Position the
paper guide roll'er in the middle of the sprocket
shaft.
STEP 2.
I nsert the sheet paper (letter paper) into the paper
guide at the rear part of the printer mechanism.
STEP 3.
Return the release lever and advance the paper by
turning the manual feed knob.
STEP 4.
Set the paper free by the release lever and to square
up and posi
t
ion the paper.
A long sheet of paper can be squared up by aligning
the one side edge of the paper.
STEP
4'.
A short sheet of paper can be squared up by paral
leling the leading edge of the paper to the paper
position adjustment marking on the platen cover of
the tractor un
it.
(Refer to the ill ustration on the
right.)
STEP 5.
Position the paper according to the paper position
markings as shown in the right illustration.
If the leading edge of the paper is al igned with the
1/4 position marking line (a lower line), printing is
started from 28.6mm below the leading edge. If
aligned with the 1/8 position marking line {an
upper line}, printing starts from 30.2mm below the
top.
STEP 6.
Return the release lever, scale, and printer cover as
before.
(Note)
• Move the sprocket units to the both ends and lock them in the position.
• The maximum length of sheet paper capable of printing by this printer is 12 inches (305mm). With
the longer sheet paper, printing may be deviated.
• Generally, printing is not possible in 7.5mm from the bottom.
• Carbon paper for copying can not be used in principle.
~"
Paper
Letter size paper
A4 size paper
I~
! i
i
I
v~
~
r
9
Advertisement
Table of Contents
