Sharp MX-M350U Operation Manual page 25

15
Touch the one-touch key for the desired
destination.
READY TO SEND.
TO CC BCC
TEST1 TEST2
TEST3 TEST4
TEST5 TEST6
FREQUENT USE ABCD EFGHI JKLMN OPQR
NOTE
In addition to touching a one-touch key, a destination
can be specified by entering a search number. It is
also possible to directly enter an address, or search
for an address in a global address book. For more
information, see
METHODS" (page 2-11).
16
Touch the [TO] key.
READY TO SEND.
TO
TEST1 TEST2
TEST3 TEST4
TEST5 TEST6
FREQUENT USE ABCD EFGHI JKLMN OPQRS
NOTES
● Refer to
page 1-8 to 1-9
programming one-touch key destinations.
● When touching a one-touch key, corresponding
information from the email destination screen is
shown in the message display. Up to 35 characters
can be displayed in the message screen,
regardless of the number of characters that have
been entered.
● Multiple destinations can be selected for a
broadcast transmission
17
Set special functions as needed.
RNET-FAX
ADDRESS BOOK
E SWITCH
ADDRESS REVIEW
SPECIAL MODES
ESS ENTRY FILE
(page 3-10) and Transaction report
touching the [SPECIAL MODES] key.
The key you touched is
highlighted. If you touch
the wrong key, touch the
key again to cancel the
selection. The key
display will return to
normal.
"DESTINATION INPUT
for information on
(page 2-13).
You can set the Program
(page 3-3), Erase
function (page 3-4), Dual
page scan function
(page 3-5), Timer
function (page 3-6), 2 in
1 (page 3-7), Card shot
(page 3-8), Job build
(page 3-11) by
18
If desired, touch the [FILE] key or the [QUICK
FILE] key.
MODE SWITCH
ADDRESS REVIEW
SPECIAL MODES
ADDRESS ENTRY FILE
SEND SETTINGS QUICK FILE
function, see "DOCUMENT FILING FUNCTION"
in chapter 7 of the operation manual (for general
information and copier operation).
If the [FILE] key is greyed out, only the [QUICK
FILE] key can be selected.
When you touch the [QUICK FILE] key, a message
asking you to confirm the save will appear. Touch
the [OK] key in the message screen and go to the
next step.
If you wish to cancel the save, touch the [QUICK
FILE] key after touching the [OK] key so that the
[QUICK FILE] key is no longer highlighted.
Using the automatic document feeder
19
Press the [START] key.
makes a beep sound to inform you that the
transmission job is stored and the [JOB STORED]
appears in the message display.
Using the document glass
19
Press the [START] key.
2-8
SENDING AN IMAGE
These keys are used to
store the scanned image
in the machine's hard
disk. The stored image
can be printed or
transmitted again at a
later time.
For information on this
Scanning begins and the
transmission job is stored.
(The job is transmitted
after previously stored
transmission jobs have
been completed.)
If scanning is completed
normally, the machine
The original is scanned
and the [READ-END]
key appears.