Removal and Replacement
Removing and Replacing a Bulk Power Supply
Removing a BPS
Figure 4-15
BPS Detail
Step 1. Pull the extraction levers located on the upper front outer portion of the BPS.
Step 2. Slide the BPS forward using the extractions levers to remove it from the chassis.
Replacing a BPS
Step 1. Verify that the extraction levers are in the open position, then insert the BPS into the empty slot.
NOTE
Step 2. Ensure the BPS has seated by closing the extraction levers.
NOTE
76
The BPS easily slides into the chassis; however, a slow firm pressure will be needed
to properly seat the connection.
BPS LED should show BPS operational and no fault. BPS LED should be GREEN.
Chapter 4