Front Panel Security Lockout (Executive Mode); Program Audio; Single Switcher Mode; Separate Switcher Mode - Extron electronics MPS 112 User Manual

Front panel security lockout (Executive mode)

To prevent unauthorized changes, Executive mode locks all functions except input
selection functions and Program Audio Volume control. To toggle the Executive
mode on or off, press and hold the Mode button for more than 2 seconds until the
front panel LEDs change to View mode, then press and release the fourth input
button of the VGA/Audio group. The Exec Mode LED turns on to indicate that
Executive mode is on, and it turns off to indicate Executive mode is off. Release the
Mode button when your selection has been made.

Program audio

Single Switcher mode

In Single Switcher mode, audio from the one selected input is routed to the
program audio output.

Separate Switcher mode

In Separate Switcher mode, the selected audio input from one of the three input
groups is routed to the program audio output. The selected input and group is
indicated by a flashing input LED. The LEDs of the two remaining, unselected
groups (inputs) are steadily lit.
To route a different audio input within the same input group to the program audio
output, press one of the other input buttons within that group. The flashing LED
moves to the new input. See the illustrations below.
To route an audio input from a different group to the program audio, press the
input button once if the input is already active and its LED is steadily on, or twice if
the input is not active and its LED is off. The flashing LED moves to the new input
within the new group. See the illustrations below.
1.
1
MODE
Press and hold the Mode button and press the Separate button to
select Separate Switcher mode.
NOTE The mode does not change until the Mode button is released.
2.
To select a different
input in the same input
group:
To select an input in a
different input group:
VGA / AUDIO S-VIDEO / AUDIO
2 3 4 1 2
SINGLE SEPARATE
S-VIDEO / AUDIO
1 2 3
Press a different button
in the same input group.
VGA / AUDIO
1 2 3
MODE SINGLE SEPARATE
Press a button in a different input group
• once (1x) if the input is active and its LED is lit
or
• twice (2x) if the input is not active and its LED is not lit
VGA / AUDIO
1 2 3
MODE SINGLE SEPARATE
The newly selected input's LED flashes,
indicating that it is the source for program audio.
VIDEO / AUDIO
3 4 1 2 3 4
PROG VOL RESET MIC VOL RESET MIC POWER ON/OFF
LEDs for the last- selected inputs in the
other switching groups light steadily.
S-VIDEO / AUDIO
4 1 2 3
The newly selected
input's LED flashes.
S-VIDEO / AUDIO
4 1 2 3 4
S-VIDEO / AUDIO
4 1 2 3 4
MPS 112 Series • Operation
4
3-5