Extron electronics MPS 112 Series Setup Manual

VGA / AUDIO
1 2 3 4 1
MODE SINGLE SEPARATE
This guide provides basic instructions for an experienced installer to set up
and operate the Extron MPS 112/112CS media switcher.
Installation
Step 1 — Disconnect power
Turn off or disconnect all equipment power sources.
Step 2 — Mount the unit
Select a mounting option and install the appropriate brackets. Mount the switcher.
Step 3 — Connect video inputs
Attach up to four VGA, four S-video, and four Video (composite) input devices to the MPS switcher.
Step 4 — Connect video outputs
Connect a VGA output, an S-video output, and a Video (composite) output from the switcher to the appropriate projector inputs.
Step 5 — Connect audio inputs
For stereo input, connect up to 12 audio sources to the audio inputs of the VGA, S-video, or Video (composite) groups (up to
four audio sources for each group). Stereo audio in the VGA group is input via standard 3.5mm stereo mini connectors. Stereo
or mono audio in the Video and S-Video groups are input on standard female RCA connector pairs.
Step 6 — Connect Mic input
If a microphone is required, connect it to the 1/4" connector on the
MPS 112 or the 3-pole, 3.5mm captive screw connector on the MPS 112CS,
as shown.
Step 7 — Connect audio outputs
For stereo audio output, connect an audio output device to each of the three output groups. Connect an audio amplifier to the
Program Audio output connectors (female RCA connectors on the MPS 112, 3.5mm captive screw connectors on the MPS 112CS).
Sleeve(s)
Step 8 — Connect RS-232 port
If the MPS switcher is to be connected to a computer or host controller for remote
control, connect the host RS-232 cable to the switcher 9-pin female RS-232 remote
connector. For additonal information, see the "Remote Control Port (RS-232)" section
in chapter 5 of the MPS 112 User's Manual.
RS-232 protocol:
• 9600 baud • no parity
• 8 data bits • no flow control
• 1 stop bit
Setup Guide — MPS 112 Series
S-VIDEO / AUDIO VIDEO / AUDIO
2 3 4 1 2 3 4
PROG VOL RESET MIC VOL RESET MIC POWER ON/OFF
Tip
Ring
Tip
Ring
Balanced Audio Output
Do not tin the wires!
MPS SERIES
MEDIA PRESENTATION SWITCHER
PROGRAM AUDIO MIC
VOLUME
VOLUME
MUTE MIX
Tip
Sleeve
Unbalanced Mic Input
Tip
NO Ground Here
Sleeve(s)
Tip
NO Ground Here
Unbalanced Audio Output
CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT
connect the sleeve(s) to the
negative (-) contacts.
RS-232 Pin
Configuration
Pin Signal
2 Tx
3 Rx
5 Ground
Tip
Ring
Sleeve
Balanced Mic Input
5 1
9 6
DB9 Pin Locations
Female
RS-232 remote connector
(Continued on reverse side)