Connect The Usb Cable - Xerox Travel Scanner 150 User Manual

Connect the USB Cable

The scanner does not have an external power supply. It draws its power directly from the computer through the USB
cable. If you use a USB hub with your computer, the hub must have its own power supply. The scanner does not
have an on/off switch. The scanner is ready to scan as soon as its software is finished loading onto your computer.
After you plug in the scanner you will be prompted perform a calibration. Please have your calibration page ready.
1. Remove any tape from the USB cable.
2. Plug the USB cable into the USB port on the scanner then into a USB port on the computer.
If the plug does not attach easily, make sure that you are plugging it in correctly. Do not force the plug into
either connection.
Your computer recognizes that a scanner has been plugged into the USB port and automatically loads the
appropriate software to run the scanner. If your computer is running Windows version XP or later, you will see a
message similar to the one below.
26 Xerox Travel Scanner 150
User's Guide