Connect The Usb Cable And Turn On The Power; Install The Visioneer Scan Utility; Installing Additional Applications - Xerox Duplex Combo User Manual

®
Xerox Duplex Combo Scanner

Connect the USB Cable and Turn on the Power

If you did not connect the scanner earlier, proceed with the instructions below.
1. Remove any tape from the USB cable.
2. Plug the USB cable into the USB port on the scanner then into a USB port on the computer.
Check your computer's manual for USB port locations.
If the plug does not attach easily, make sure that you are plugging it in correctly. Do not force
the plug into either connection.
3. Turn on the scanner power.
The status light comes on and flashes indicating that the scanner is receiving power.
Your computer recognizes that a scanner has been plugged into the USB port and
automatically loads the appropriate software to run the scanner.

Install the Visioneer Scan Utility

The Visioneer Scan Utility software installation will start automatically after you click Close on
the driver Installation Complete window. Follow the instructions on the screen to install the
application.
Software About the Software
Visioneer Scan This utility uses the scanner's TWAIN interface for scanning. You can select a
Utility destination folder on your computer and save the image as any one of several
popular image file formats (BMP, JPG, GIF, TIF, Multi-Page TIF, PDF, Multi-Page PDF).

Installing Additional Applications

1. Return to the disc's Main menu and click Install software.
2. If a version of the software is already installed on the system, the option will be greyed out.
However, if there is a newer version available on the disc or online, it will be possible to
upgrade by selecting the appropriate button option.
4-6
Installation
User Guide