Connect The Usb Cable And Turn On The Power - Xerox D70n User Manual

®
Xerox D70n Scanner
Note: If you do not see this on-screen diagram for connecting the scanner, stop and follow
the instructions below.

CONNECT THE USB CABLE AND TURN ON THE POWER

If you did not connect the scanner earlier, proceed with the instructions below. It is recommended
that the cable provided with the scanner is the one used.
1. Remove any tape from the USB cable.
2. Plug the USB cable into the USB port on the scanner then into a USB port on the computer.
Check your computer's manual for USB port locations. If the plug does not attach easily,
make sure that you are plugging it in correctly. Do not force the plug into either connection.
3. Press the power button to turn on the scanner power.
The status light comes on and flashes indicating that the scanner is receiving power.
Your computer recognizes that a scanner has been plugged into the USB port and
automatically loads the appropriate software to run the scanner.
4. When you're certain that the software has completely loaded, return to the "Complete the
installation by connecting your hardware" window.
5. Click OK to complete the installation process.
5-4
PC Installation
User Guide