SOYO SY-P4I875P DRAGON 2 V1.0 User Manual page 60

BIOS Setup Utility
3-1.3 OnChip IDE Device
Caution: Change these settings only if you are already familiar
with the IDE settings.
The [OnChip IDE Device] option changes the settings of the 82801ER
(ICH5R) IDE controller. These settings do not influence the ALi M5281
controllers.
The following screen shows setup default settings.
Phoenix – Award BIOS CMOS Setup Utility
IDE 1,2 /SATA 1,2
IDE HDD Block Mode
IDE DMA transfer access
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
*** On-Chip Serial ATA Setting ***
SATA Mode
On-Chip Serial ATA
x Serial ATA Port0 Mode
x Serial ATA Port1 Mode
:Move Enter:Select
F5:Previous Values
After you have completed the changes, press [Esc] and follow the instructions
on your screen to save your settings or exit without saving.
SY-P4I875P DRAGON 2 V1.0
OnChip IDE Device
IDE only
Enabled
Enabled
Enabled
Auto
Auto
Auto
Auto
Enabled
Auto
Auto
Auto
Auto
IDE
Disabled
Primary Master
Primary Slave
+/-/PU/PD:Value F10:Save
F6:Fail-Safe Defaults
55
Item Help
Menu Level
[Disabled]: Disabled SATA
Controller.
[Auto]: Auto arrange by
BIOS.
[Combined Mode]: PATA
and SATA are combined.
Max. of 2 IDE drives in each
channel.
[Enhanced Mode]: Enable
both SATA and PATA. Max.
of 6 IDE drives are
supported.
[SATA Only]: SATA is
operating in legacy mode.
ESC:Exit F1:General Help
F7: Optimized Defaults