SOYO SY-P4I875P DRAGON 2 V1.0 User Manual page 33
Mpga socket 478 processor supported intel 875p agp/pci 533/800 mhz front side bus supported atx form factor
Hide thumbs
Also See for SY-P4I875P DRAGON 2 V1.0:
- User manual (145 pages) ,
- User manual (143 pages) ,
- User manual (133 pages)
Table of Contents
Advertisement
Hardware Installation
5. IDE LED
Attach the 2-pin IDE device LED cable to the corresponding IDE LED
header on the Motherboard. This will cause the LED to light when an IDE1 or
IDE2 (HDD, CD-ROM) device is active.
HDD LED Pin Assignment
6. ATX Power On/Off Switch
Attach the 2-pin momentary type switch to the PWRBT header for turning On
or Off your ATX power supply. Note that 5VSB will always have power, so
the 5V standby LED will always be lit.
PWRBT Pin Assignment
Power On/Off
SY-P4I875P DRAGON 2 V1.0
_
+
LED Anode LED Cathode
1
GND
28
Advertisement
Table of Contents
Troubleshooting
