SOYO SY-P4I875P DRAGON 2 V1.0 User Manual page 130

Sometimes the system finds my CD-ROM, sometimes not
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the
peripherals. If your system has other peripherals connected, like
CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer I get "floppy boot failure" and the LED
on the floppy stays on
1. Make sure the red wire of floppy ribbon cable goes to Pin1 on the
floppy drive side (don't trust the "key lock" or "notch") and use the
end-connector of the cable (don't use middle one).
2. Some floppy drivers have their own jumper to make the same twist as
the twist on the cable. Make sure this jumper is set not to "twist" the
cable while the floppy drive is connected to the twisted end of the
cable.
RAID issue
Windows does not detect the on-board RAID.
1. Enable the on-board RAID function in the BIOS.
2. Install the RAID driver, see chapter 6 for more info.
Can I use my CD-ROM or other IDE device (except HDD) on IDE 3 & 4, SATA
1-4?
No, the IDE3,4 and all SATA ports only support Hard disks.
Can I use IDE 3 & 4 and / or SATA 3-4 as a normal IDE channel?
Yes, no need to change any settings in the BIOS. Just make sure to install the driver,
check Chapter 6 for more info.
I cannot get the HDD to boot from IDE 3 or IDE 4, why?
Make sure that the 1st boot device in the BIOS is set to "other device" and then set the
"other device boot order " to "IDE3,4/SCSI" .
Boot-up from my IDE3/4, I get blue screen upon entering Windows system
Make sure the raid option in the BIOS is enabled.
125