Table of Contents
Advertisement
Shutting down the projector
1.
Press
confirmation message displays prompting you.
If you don't respond in a few seconds, the
message will disappear. If you use the remote
control, press OFF to shut down the projector.
2.
Press
time. The POWER indicator light flashes
orange, the projection lamp shuts down, and
the fans will continue to run to cool down the
projector.
•
To protect the lamp, the projector will not respond
to any commands during the cooling process.
•
To shorten the cooling time, you can also activate
the Quick Cooling function. See
on page 77
3.
Once the cooling process finishes, the POWER indicator light is a steady orange
and fans stop.
4.
Disconnect the power cord from the power putlet if the projector will not be used
in an extended period of time.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns orange.
•
Actual lamp lives may vary due to different environmental conditions and usage.
66
Operation
Power on the projector. A
I
I
Power on the projector a second
I
I
for details.
"Quick Cooling"
Advertisement
Table of Contents
