Table of Contents
Advertisement
FUNCTION
Picture Mode
Reference
Mode
Brightness
Contrast
Color
Tint
Sharpness
74
Operation
DESCRIPTION
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
picture mode" on page 39
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See
for details.
This function is only available when User 1 or User 2 is selected.
Adjusts the brightness of the image. See
page 40
for details.
This function is only available when User 1 or User 2 is selected.
Adjusts the degree of difference between dark and light in the image.
See"Adjusting Contrast" on page 40
This function is only available when User 1 or User 2 is selected.
Adjusts the color saturation level -- the amount of each color in a
video image. See
"Adjusting Color" on page 40
This function is only available when User 1 or User 2 is selected.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC or PAL.
Adjusts the red and green color tones of the image. See
Tint" on page 40
for details.
This function is only available when User 1 or User 2 is selected.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC or PAL.
Adjusts the image to make it look sharper or softer. See
Sharpness" on page 40
This function is only available when User 1 or User 2 is selected.
for details.
"Setting the User 1/User 2 mode" on page 39
"Adjusting Brightness" on
for details.
for details.
"Selecting a
for details.
"Adjusting
"Adjusting
Advertisement
Table of Contents
