Table of Contents
Advertisement
Main Menu
Table of Contents
HomeLink Universal Transceiver
Press and hold the remote control
3.
button and one of the HomeLink
buttons at the same time.
The remote control
Canadian Owners:
you are training from may stop
transmitting after 2 seconds. This is
not long enough for HomeLink to
learn the code. Release and press the
button on the remote control every 2
seconds until HomeLink has learned
the code.
4.
The red light in HomeLink should
begin flashing. It will flash slowly
at first, then rapidly.
5.
When the red light flashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control.
6.
Plug in the garage door opener
motor, then test the HomeLink
Transceiver button by pushing it.
146
Comfort and Convenience Features
If the button does not work, repeat
this procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
for 2 seconds, then stays on, you
have a rolling code garage door
opener. Go to ''Training With a
Rolling Code System''.
7.
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
Training With a Rolling Code
System
For security purposes, newer garage
door opening systems use a ''rolling''
or variable code. Information from
the remote control and the garage
door opener are needed before
HomeLink can operate the garage
door opener.
The ''Training HomeLink''
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so they send and
receive the correct codes.
Advertisement
Table of Contents
