Setup; Ac Power; Ac Plug; Fuse Replacement - Chauvet Legand 230SR BEAM User Manual

Setup

3. Setup

AC Power

AC Plug

Fuse Replacement

DMX Linking

DMX Modes

6
Each Legend™ 230SR Beam has an auto-ranging power supply that works with an input
voltage range of 100~240 VAC, 50/60 Hz. To determine the power requirements for
each Legend™ 230SR Beam, refer to the label affixed to the product. You can also refer
to the Technical Specifications.
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download Sizing Circuit Breakers from the CHAUVET®
website: www.chauvetpro.com.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0% to 100% switch.
The Legend™ 230SR Beam comes with a bare ended power input cord. The product
side of this power cord enters the product through a strain reliever (rubber boot) and it
cannot be disconnected from the product. Use the table below to wire the plug to the
power cord.
Connection
AC Live
AC Neutral
AC Ground
Make sure to disconnect the product's power cord before replacing a blown fuse.
Always replace with a fuse of the same type and rating.
1. Disconnect this product from the power outlet.
2. Using a Phillips #2-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a good fuse of the same type and rating
(T 5 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
You can link the Legend™ 230SR Beam to a DMX controller using a standard DMX
serial connection. If using other DMX compatible products with the Legend™ 230SR
Beam, you can control each individually with a single DMX controller.
The Legend™ 230SR Beam uses the standard DMX data connection for the 15 and 18
channel DMX modes.
• Refer to the Introduction
• Refer to Operation to learn how to configure the Legend™ 230SR Beam to work in
these modes.
• The DMX Values section will provide detailed information regarding the DMX modes.
If you are not familiar with or need more information about DMX standards,
Master/Slave connectivity, or the DMX cables needed to link this product to a DMX
controller, download
www.chauvetpro.com.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
for a brief description of these modes.
the DMX Primer
Screw Color
Brown Yellow or Brass
Blue
from the CHAUVET®
Legend™ 230SR Beam User Manual Rev. 1
Silver
Green
website: