Product At A Glance; Safety Notes; Personal Safety; Mounting And Rigging - Chauvet Legand 230SR BEAM User Manual

Before You Begin

Product at a Glance

Safety Notes

Personal Safety

Mounting and Rigging

Power and Wiring

Operation

2
Use on Dimmer
Outdoor Use
Sound Activated
DMX
Master/Slave
Product must be placed so that any objects being hit by the beam of light are at
least 40 feet (12.2 meters) away!
Please read the following Safety Notes carefully before starting to work with the product.
These notes provide important safety information about the installation, usage, and
maintenance.
This product contains no user-serviceable parts. Any reference to servicing in this
User Manual will only apply to properly trained CHAUVET® certified technicians.
Do not open the housing or attempt any repairs.
Please refer to all applicable local codes and regulations for the proper installation
of the product.
• Avoid direct eye exposure to the light source while the product is on.
• Do not turn product on without a lamp!
• Always disconnect this product from its power source before servicing.
• Always connect this product to a grounded circuit to avoid the risk of electrocution.
• Do not touch this product's housing during operation because it may be very hot.
• This product is for indoor use only! To prevent risk of fire or shock, do not expose this
product to rain or moisture.
• This product weighs 41.3 lbs (18.73 kg). Always ask for help when mounting this
product to avoid personal injuries or damage to the product.
• Make sure there are no flammable materials close to this product while it is operating.
• When hanging this product, always secure to a fastening device using a safety cable
(included).
• Always carry this product by the handles. Do not carry from the head.
• Always make sure you are connecting this product to the proper voltage in
accordance with the specifications in this manual or on the product's specification
label.
• Never connect this product to a dimmer pack or rheostat.
• Never disconnect this product by pulling or tugging on the power cable.
• Do not operate this product if you see damage on the housing, lenses, ultraviolet
filter, or cables. Have the damaged parts replaced by an authorized technician at
once.
• Do not cover the ventilation slots when operating to avoid internal overheating.
• Do not aim this product toward the Sun. The lenses could concentrate the solar
energy and cause internal overheating.
• Do not aim this product toward fire sprinkler head or alarms. The beam could heat up
the sensors causing them to go off.
• Mount this product in a location with adequate ventilation, at least 40 ft. (12.2 m) from
objects to be lit.
• The maximum ambient temperature is 104° F (40° C). Do not operate this product at a
higher temperature.
• In case of a serious operating problem, stop using this product immediately!
In the unlikely event that your CHAUVET® product may require service, contact
CHAUVET® Technical Support.

Auto Programs
Auto-Ranging Power

Supply

Replaceable Fuse

User Serviceable

Duty Cycle
Legend™ 230SR Beam User Manual Rev. 1




