Table of Contents
Advertisement
Chapter 11 Network Address Translation (NAT)
11.2.1 Add/Edit Port Forwarding
Click Add new rule in the Port Forwarding screen or click the Edit icon next to an existing rule to
open the following screen.
Figure 65 Port Forwarding: Add/Edit
The following table describes the labels in this screen.
Table 46 Port Forwarding: Add/Edit
LABEL
Active
Service Name
WAN Interface
Start Port
End Port
Translation
Start Port
Translation End
Port
Server IP
Address
Protocol
OK
Cancel
158
DESCRIPTION
Clear the checkbox to disable the rule. Select the check box to enable it.
Enter a name to identify this rule using keyboard characters (A-Z, a-z, 1-2 and so on).
Select the WAN interface through which the service is forwarded.
You must have already configured a WAN connection with NAT enabled.
Enter the original destination port for the packets.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port field.
Enter the last port of the original destination port range.
To forward only one port, enter the port number in the Start Port field above and then
enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with the port
number in the Start Port field above.
This shows the port number to which you want the VMG to translate the incoming port. For
a range of ports, enter the first number of the range to which you want the incoming ports
translated.
This shows the last port of the translated port range.
Enter the inside IP address of the virtual server here.
Select the protocol supported by this virtual server. Choices are TCP, UDP, or TCP/UDP.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
VMG5313-B10A/-B30A Series User's Guide
Advertisement
Table of Contents
