Table of Contents
Advertisement
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 20 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode)
The following table describes the fields in this screen.
Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode)
LABEL
General
Name
Type
Mode
VLAN
802.1p
802.1q
QoS
Rate Limit
Apply
Cancel
If you select ADSL over ATM as the interface type, the following screen appears.
Figure 21 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge
Mode)
VMG5313-B10A/-B30A Series User's Guide
DESCRIPTION
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The VMG uses
the VDSL technology for data transmission over the DSL port.
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
This section is available only when you select ADSL/VDSL over PTM in the Type field.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Chapter 6 Broadband
77
Advertisement
Table of Contents
