Table of Contents
Advertisement
Chapter 8 Home Networking
Click Apply to save your settings.
3
Figure 42 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 24 Network Setting > Home Networking > LAN Setup
LABEL
Interface Group
Group Name
LAN IP Setup
IPv4 Address
Subnet Mask/
Prefix Length
IGMP Snooping
Status
IGMP Mode
DHCP Server State
DHCP
DHCP Relay
Server Address
IPv4 Address
IP Addressing
Values
Beginning IP
Address
Ending IP
Address
Auto reserve IP
for the same
host
116
DESCRIPTION
Select the interface group name for which you want to configure LAN settings. See
13 on page 173
for how to create a new interface group.
Enter the LAN IPv4 IP address you want to assign to your VMG in dotted decimal notation,
for example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your VMG automatically computes the subnet mask based
on the IP Address you enter, so do not change this field unless you are instructed to do so.
Select the Enable IGMP Snooping checkbox to allows the VMG to passively learn multicast
group.
Select Standard Mode to have the VMG forward multicast packets to a port that joins the
multicast group and broadcast unknown multicast packets from the WAN to all LAN ports.
Select Blocking Mode to have the VMG block all unknown multicast packets from the WAN.
Select Enable to have the VMG act as a DHCP server or DHCP relay agent.
Select Disable to stop the DHCP server on the VMG.
Select DHCP Relay to have the VMG forward DHCP request to the DHCP server.
This field is only available when you select DHCP Relay in the DHCP field.
Enter the IPv4 IP address of the actual remote DHCP server in this field.
This field is only available when you select Enable in the DHCP field.
This field specifies the first of the contiguous addresses in the IP address pool.
This field specifies the last of the contiguous addresses in the IP address pool.
Select Enable to have the VMG record DHCP IP addresses with the MAC addresses the IP
addresses are assigned to. The VMG assigns the same IP address to the same MAC address
when the host requests an IP address again through DHCP.
VMG5313-B10A/-B30A Series User's Guide
Chapter
Advertisement
Table of Contents
