This section explains how to effectively operate the projector once it has been installed. It
is recommended that you read this section and familiarize yourself with the components
and the available menu options before you begin using your projector for the first time.
Top IR Sensor
Figure 3.1 Projector Basics
The built-in keypad is located at the back of the projector, beside the input panel. Use it
similarly to the IR remote to control the projector. A status LED display is also included on
this keypad for monitoring projector status.
The AC receptacle is located at the back of the projector just below the input panel. Use
this outlet to plug in an appropriately rated power cord. Refer to Section 6 — Specifications
for details.
Located on the underside of the projector are two fully adjustable feet. Raise or lower
these feet when positioning the projector to ensure it is level on all sides so the displayed
image will appear rectangular without any keystone. NOTE: The third foot, located at the
rear of the projector (underside) is not adjustable.
Refer to Section 2 — Adjusting Projector Height for instructions on how to adjust the
projector's feet.
Front IR Sensor
Adjustable Feet (2)
Status LED Display
Built-in Keypad
Input Panel
Lamp Door
AC Receptacle
Non-adjustable Foot
25
3.1 About the Projector
Projection Lens
SECTION 3
Operation
Built-in Keypad
AC Receptacle
Adjustable Feet