Basic Operation - Runco Reflection CL-410 Owner's Operating Manual

Basic Procedure
Connect the required external equipment to the projector before completing the following
procedures. The display language preset at the factory is English. For information on
changing the display language, see "Display Language" on page 27.
1 Plug the power cord into the wall outlet. The power indicator lights blue, and the
projector enters standby mode.
2 Press the power (ON) button on the remote control. The blue power indicator turns
off.
Temperature
Indicator
Remote
Control
Sensor
Note:
Power indicator:
• The power indicator lights up, indicating the status of the projector.
Blue: The projector is in standby mode.
Blue blinking: The fan is cooling.
Blue light off: The projector is on.
• You may need to wait several seconds for the projector to warm up before light
is projected.
Temperature indicator:
• The projector has a temperature warning LED on the control panel. If the projector
overheats because of a dirty filter or any other problem, the LED flashes and the
projector lamp turns off, after which a 90-second cooling off period occurs. After
restarting the projector, if the unit doesn't operate normally, take the projector for
servicing.
Power Remote
Indicator Control
(Blue) Sensor

Basic Operation

25