Velocities - M-Audio Trigger Finger Pro User Manual

M-audio trigger finger pro usb controller user guide
Table of Contents

Advertisement

Velocities

Each pad used in a Sequence can play its notes at independent velocities for each step, which you
can edit.
To edit step velocities:
1.
Enter Sequence Mode by pressing the Sequence Mode (Seq) button.
2.
Check above the third Function Button (Page) to make sure you are viewing Page 1. If you are
on Page 2, press the button to move to Page 1.
3.
Press the second Function Button (Edit Velocity). The steps of the Sequence will be shown in
the display with the steps' numbers in the first (top) row and their corresponding velocity values
below them in the second row.
4.
Before editing any values, make sure you have selected the desired bar and pad of the
Sequence:
Select the desired pad either by simply pressing it (in the desired pad bank) or by turning the
first and/or second Assignable Knobs (Bank and Pad).
Select the desired bar either by turning the third Assignable Knob (Bar) or pressing and
holding Select and then pressing one of Step Indicators 1-5.
5.
Turn the Value Dial to select a step, and then press the Value Dial to select its velocity. (The
currently selected step number or velocity value will flash.)
6.
Turn the Value Dial to adjust the velocity value (00–127).
If you want to tie the step to the previous one (creating a "held" note), press the first Function
Button (Tie) to activate or deactivate the tie function. Alternatively, press and hold a Step
Switch for two seconds. When a step is tied, the step before it will determine the velocity, and
its Step Switch will be partially lit. You can tie multiple steps in a row.
To erase all steps for that pad, press the second Function Button (Clr Pad). Be careful—this
cannot be undone!
To erase all steps for all pads in the Sequence, press the third Function Button (Clr All). Be
careful—this cannot be undone!
7.
To select a different step, press the Value Dial and then repeat Steps 4-6.
8.
Make other changes, or exit Sequence Mode by pressing the Sequence Mode (Seq) button or
fourth Function Button (Exit) twice.
65

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents