Table of Contents
Advertisement
To erase all steps from the entire Sequence:
1.
Enter Sequence Mode by pressing the Sequence Mode (Seq) button.
2.
Check above the third Function Button (Page) to make sure you are viewing Page 2. If
you are on Page 1, press the button to move to Page 2.
3.
To erase all steps for all pads in the Sequence, press the second Function Button (Clear
All). Be careful—this cannot be undone!
4.
Make other changes, or exit Sequence Mode by pressing the Sequence Mode (Seq)
button or fourth Function Button (Exit) twice.
Tip: You can perform the same function while editing step velocities by pressing the third
Function Button (Clr All) on that page. See the following Velocities section to learn
more.
1:
2:
3:
4:
127
00
00
00
BANK:A
PAD:A01 BAR:Auto VEL:127
5:
6:
7:
8:
9:
00
00
00
00
127
10:
11:
12:
13: 14:
00
00
00
00
TIE
CLR PAD CLR ALL
64
15: 16:
00
00
00
EXIT
Hide quick links:
Advertisement
Table of Contents
