M-Audio Trigger Finger Pro User Manual page 62

To enter or erase steps in a Sequence:
1. Enter Sequence Mode by pressing the Sequence Mode (Seq) button.
2. Check above the third Function Button (Page) to make sure you are viewing Page 1. If
you are on Page 2, press the button to move to Page 1.
3. Press the pad whose sound you want to use in the current bar. The pad number will
appear in the display, and any steps for that pad in that bar will appear in the Step
Switches.
Important: See Working with Sequences: Bars to learn how to set a Sequence's bar
length and to set which bar you are viewing/editing in the Step Switches.
4. To add a step to the current bar for that pad, press an unlit Step Switch. (To learn how to
add or remove a tie, see the Velocities section.)
To remove a note event from the current bar for that pad, press a lit Step Switch.
Important: A newly entered step's default velocity will be 127 unless you have set a
different Sequencer Velocity value. See the following Velocities section to learn how to
set a different default Sequencer Velocity.
5. Make other changes, or exit Sequence Mode by pressing the Sequence Mode (Seq)
button or fourth Function Button (Exit).
62